IOGear GWHDMS52MB User Manual

Page 21

Advertising
background image

21

Item / Mode

Status

Description

Tx / Rx

Power LED

Tx/Rx Source

/ Video LED

Rx Wireless

LED

OSD Display

Standby

For power saving
mode.

Static Red

OFF

OFF

Initial Boot
up / Warm
up

It will spend 15 ~
20 seconds for
system boot up.

Tx Blinking
Green
Rx Static
Green

Blinking

Blinking

Searching
available
channels

Continuing search
available channels
If system can’t
establish link
over 80s after
initialization.

Tx Blinking
Green
Rx Static
Green

Blinking

Blinking

Wireless
linked Mode

No input from
selected source
(Note B)

Static Green

Blinking
(Quickly)

Static Green

Video format not
recognized
(Note C)

Static Green

Blinking
(Slowly)

Static Green

Video format is
recognized

Static Green

Static Green

Static Green

-

Notes:
A. Please make sure the source device has been powered ON and the signal output is set to

HDMI out; also try to re-plug the HDMI cable to make sure the HDMI connector is seated
properly.

B. If there is no video displayed and OSD display shows “Not Supported Format”, this is

an indication that the video resolution or frame rate from the computer is not supported,
please refer to page 20 to switch to a supported video resolution.

C. If you have more than one pair of this product, each transmitter and receiver should be at

least 6.5 feet away from one another.

D. If the RF connection boot-up has exceeded 80 seconds and still not established a link

between the transmitter and receiver, it is due either to lost link or the transmitter is most
likely out of range. You may have to verify the range and adjust or shorten the distance
between your HDTV set with the transmitter and the receiver. The maximum video
transmission range for 1080p content is up to 200ft. The minimum range is 6.5ft.

4 levels
looping

Looping display
these two OSD

x

x

5. If the Operation is normal, the Power / Wireless status LED and Source Status LED will

glow in solid green, please refer to the LED status table below that contains detailed LED
indicator and OSD descriptions for the transmitter and receiver:

Advertising