Basic operation – IOGear GWHDMS52MB User Manual
Page 19
Advertising
19
Basic Operation
1. After initial setup, plug the power adapters for both the Transmitter and Receiver into an
available power outlet.
Note: The HDMI OUT on the Transmitter will always be active, even when in Standby mode.
(For more information about Standby Mode, refer to page 21)
2. Once the Transmitter and Receiver have been powered ON, the LED indicators will light
green and begin the start-up process.
3. During start-up, the
Source LED indicators on the Transmitter and the Wireless Signal
status LED on the Receiver will flash green until the signal link has been established with
the Transmitter. This process takes approximately 30 seconds.
30 seconds
Advertising