AirLive WL-2600CAM - Manual (Page 26)

AirLive WL-2600CAM User’s Manual 25
6.1.3 Initialize
¾ Reboot: Click this bottom to reboot this IP Camera. A confirmation dialogue will appear and then
click “OK” to process. It takes two minutes to reboot this IP Camera.
¾ Factory Default: Click this bottom to reset this IP Camera to the factory default setting. A
confirmation dialogue will appear and then click “OK” to process. The network indicator on this IP
Camera will start to blink. This IP Camera will reboot automatically after completing adjustments to
the default setting. Don't turn off this IP Camera until the device reboots.
¾ Backup Setting: You can save the setting data of this IP Camera into a file. Click “Save” and
follow the instructions on the browser to save the setting data file to your specified location.
¾ Restore Setting: Download the saved setting data of this IP Camera. Click “Browse” and select
saved file. Click “OK” and this IP Camera is adjusted according to the loaded data and then restarted.
¾ Firmware Update: Upgrade the device software. Click “Browse” and select the file for upgrading. A
confirmation dialogue will appear. Click “OK” to start upgrading. This IP Camera will reboot upon
completion.
Note:
Use only upgrade files that are special for this IP Camera. Otherwise problems may
occur. Don't turn off the IP Camera power or disconnect the network until the
upgrading is completed.
¾ Upload Language Pack: Upgrade the device language pack. Click “Browse” and select the file for
upgrading. A confirmation dialogue will appear. Click “OK” to start upgrading. The upgrade is applied
immediately. The default language is “English.”