Aladdin Light Lift ALL200RM-CM-240V - Manual (Page 13)

STEP 22
Shim and adjust chandelier pulley assembly so that winch cable hangs plumb through center of hole in
top contact plate on ceiling box. See Diagram M. Look up at ceiling box from floor level to verify cable is
plumb.
Never install the ALL200RM where the cable is not plumb through the center of the ceiling box. This
could interfere with the automatic shutoff system and could cause the chandelier to fall, which could
cause death, personal injury, and/or property damage.
STEP 23
Securely tighten chandelier pulley assembly hardware and verify that winch cable hangs plumb through
center hole in top contact plate on ceiling box. Look up at ceiling box from floor level to verify cable is
plumb. See Diagram M.
Confirm winch cable
hangs plumb through
center of hole in
top contact plate on
ceiling box.
Diagram M
View from Floor Level
STEP 24
Install directional pulleys to suitable structure using 7/16” x 3 ¼” bolts, 7/16” nylon lock nuts, and 3/8” USS
flat washers as per Diagram N. Securely tighten hardware.
Never install directional pulleys without properly fastening them to the structure. This could interfere
with the automatic shutoff system and could cause the chandelier to fall, which could cause death,
personal injury, and/or property damage.
Never install directional pulleys and/or the chandelier pulley assembly off plane. Never install
directional pulleys and/or the chandelier pulley assembly where there will be right and left hand turns in
the winch cable. This could damage the winch cable and could cause the chandelier to fall, which could
cause death, personal injury, and/or property damage. Make sure the winch cable travels straight to and
from the pulley grooves of each pulley. Make sure the winch cable is completely unobstructed between
pulleys.
Pulley
Quick Link
Flat Brackets 10.2
cm
17.8
cm
7/16” x3¼” Hex Tap Bolts
7/16” Nylon Locknuts
3/8” USS Flat Washers
15.2
cm
Suitable S
tructur
e
Diagram N
yes NO