Aladdin Light Lift ALL200RM-CM-240V - Manual (Page 17)

STEP 34
Adjust screw collar rings so top of canopy is just below edge of bottom contact plate. Canopy should be at
least 4.4cm deep. See Diagram R.
Never allow the chandelier canopy to make contact with the ceiling before the contact plates meet. This
could interfere with the automatic shutoff system and could cause the chandelier to fall, which could
cause death, personal injury, and/or property damage.
STEP 35
Loosen bottom screw collar ring to allow easy wire access. See Diagram R.
STEP 36
Run chandelier wires through screw collar or threaded stem and pull through fixture coupler holes. See
Diagram R.
STEP 37
Wire nut chandelier hot wire to black bottom contact plate wire, other hot to white, and protective earth to
green. If the chandelier has two hot wires, wire extra hot to red wire. See Diagram R. Protective earth wire
from chandelier can not touch underside of bottom contact plate. A direct short will occur.
Diagram R
Top of Canopy
Just Below Edge
of Bottom
Contact Plate
4.4cm Deep
Canopy
Wire Nut Chandelier
Wires to Bottom
Contact Plate Wires
Bottom Screw
Collar Ring
Pull Chandelier
Wires Through
Screw Collar Loop/
Threaded Stem and
Fixture Coupler