Aladdin Light Lift ALL1000RM-CM-240V - Manual (Page 10)

STEP 13
After turning off power, remove and discard existing electrical box if present in ceiling. Only use ceiling box
provided with ALL1000RM.
Never remove an existing ceiling box while the power is connected. Electricity could cause death,
personal injury, and/or property damage.
STEP 14
Cut a 11.4cm hole in ceiling for ceiling box. If you removed an existing ceiling box, existing hole may need
to be enlarged.
STEP 15
Tighten temporary weight to fixture coupler on bottom contact plate. Make sure jam nut on weight is tight.
Never install or operate an ALL1000RM before securing the temporary weight to the fixture coupler.
This could cause the temporary weight to fall, which could cause death, personal injury, and/or property
damage.
STEP 16
Fasten side brackets to chandelier pulley bracket using 3/8” x 1¼” hex tap bolts, 3/8” nylon lock nuts, and
5/16” USS flat washers. See Diagram I.
Diagram I
3/8” x 1¼” Hex Tap Bolts
5/16” USS Flat Washers
3/8” Nylon Lock Nuts