Aladdin Light Lift ALL1000RM-CM-240V - Manual (Page 8)

STEP 9
Remove dust cover by using 5/16” nutdriver or socket. Remove paper tape from winch drum while keeping
tension on winch cable.
Never operate the ALL1000RM without tension on the cable. Never remove or tamper with the cable
safety device. Never install an ALL1000RM that has the cable safety device removed or tampered
with. The cable safety device consists of the limit switch and small gauge rectangular wire and is located
directly in front of the winch drum. Removing or tampering with the cable safety device could cause the
cable to become reversed wrapped on the winch and could also cause the cable to unravel off the winch
drum and get damaged. Never install or operate an ALL1000RM that has a frayed, kinked, or otherwise
damaged cable. Never operate the ALL1000RM without first removing the paper tape from the winch
drum. Avoiding any of these could cause the chandelier to fall, which could cause death, personal injury,
and/or property damage.
STEP 10
Replace dust cover by fastening the two 5/16” self tapping screws. Locate controller wire. Controller wire is
a low voltage, gray sheathed, four conductor wire with white plugs on either end.
STEP 11
Plug controller to controller wire and operate motor down to extend winch cable to desired length for
installation. Do not operate motor up. Reference SmartLift Controller guide for operation instruction.
Keep tension on cable at all times.
Never extend the full length of winch cable from the ALL1000RM. This could cause the cable to become
reverse wrapped on the winch. An ALL1000RM installed with a reverse wrapped cable can cause the
chandelier to fall, which could cause death, personal injury, and/or property damage. Refer to the
Keyswitch or SmartLift Controller tag for correct operating instructions. Winch cable length can be
found on the ALL1000RM product sticker, shipping box, and on the front page of these installation
instructions.
Never operate the ALL1000RM without tension on the cable. Never remove or tamper with the cable
safety device. Never install an ALL1000RM that has the cable safety device removed or tampered
with. The cable safety device consists of the limit switch and small gauge rectangular wire and is located
directly in front of the winch drum. Removing or tampering with the cable safety device could cause the
cable to become reversed wrapped on the winch and could also cause the cable to unravel off the winch
drum and get damaged. Never install or operate an ALL1000RM that has a frayed, kinked, or otherwise
damaged cable. Never operate the ALL1000RM without first removing the paper tape from the winch
drum. Avoiding any of these could cause the chandelier to fall, which could cause death, personal injury,
and/or property damage.
STEP 12
Proceed to step 13 unless bottom contact plate must be removed. Follow Diagram H if and only if bottom
contact plate must be removed from winch cable. Diagram H must be followed precisely for proper
detachment and reattachment procedure. Diagram H is on next page.
Never stray from or alter the contact plate attachment/reattachment procedure. This could cause the
chandelier to fall, which could cause death, personal injury, and/or property damage.
Never detach the winch cable from the winch drum. This could cause the chandelier to fall, which could
cause death, personal injury, and/or property damage.