Aladdin Light Lift ALL1000RM-CM-240V - Manual (Page 2)

Read the following guidelines prior to installing the ALL1000RM:
I. The ALL1000RM must be installed by a licensed, bonded, and insured electrician.
II. The ALL1000RM must be installed in an accessible location.
III. Thoroughly read, understand, and follow each step and safety warning in the ALL1000RM installation
instructions and orange safety precautions supplement.
IV. Motor pulley, directional pulley(s), and chandelier pulley must be installed on the same plane. Do not
install the ALL1000RM with lateral cable direction changes.
V. During installation of the ALL1000RM, take one step at a time and check off each step upon
completion.
VI. Call Aladdin Light Lift (877) 287-4601 if assistance is needed for installation and/or operation of the
ALL1000RM. Refer to the Keyswitch Controller Guide or SmartLift Controller Guide for operation
instructions.
VII. Ignoring any safety warnings and/or symbols not only voids the warranty, but may cause death, personal
injury, and/or property damage.
VIII. The wattage of the chandelier can not exceed the wattage capacity of the ALL1000RM.
IX. Give all Aladdin paperwork to property owner and/or anyone that will be using the ALL1000RM.
ALL1000RM Parts Bag List
A. 5/16” x 2” Lag Bolts (QTY 8)
B. 5/16” x 1¼” Fender Washers (QTY 8)
C. Screw Collar Ring (QTY 1)
D. Thread Lock (QTY 1)
E. 3/32” Allen Wrench (QTY 1)
F. 1/4 IPS(13mm) x 3/8 IPS(16mm) Fixture Coupler (QTY 1)
3/8 IPS(16mm) x 1/2 IPS(22mm) Fixture Coupler (QTY 1)