AMMCO 40111 Environmental Lathe Enclosure Conversion Kit - Manual (Page 8)

8 • Important: Always read and follow operating instructions.
Drill four 5/32-inch diameter holes at location shown
to attach reed-style hood switch. Attach switch with #4
screws, washers, and nuts. Secure wire with tie wrap
through the two holes as shown.
Drill two 5/16-inch diameter holes at location shown
to attach the electrical box assembly. Use two 1/4-inch
bolts, nuts, and washers to fasten assembly to the back
of the enclosure.
940111 Kit Only