AMMCO 40111 Environmental Lathe Enclosure Conversion Kit - Manual (Page 5)

Important: Always read and follow operating instructions. • 5
Safety Notices and Decals
For your safety, and the safety of others, read and
understand all of the safety notices and decals included
here and on the unit.
Read entire manual
before installing,
operating, or servicing
this equipment.
Proper maintenance and
inspection is necessary
for safe operation.
Do not operate a
damaged lathe.
Warning
This equipment incorporates parts such as snap
switches and power receptacles which tend to produce
arcs or sparks. Therefore, when located in a service
facility, the unit should be in a room or enclosure pro-
vided for the purpose, or should be at least 18” or more
above floor to minimize the risk of igniting fuel vapors.
Cautions and Dangers
1. Eye and face protection requirements:
“Protective eye and face equipment is required to be
used where there is a reasonable probability of injury
that can be prevented by use of such equipment.”
OSHA 1910.133 (a).
Protective goggles, safety glasses, or a face shield
must be provided by the purchaser/user and worn by
the operator of the equipment. Make sure all eye and
face safety precautions are followed by the operator(s).
Keep bystanders out of the area.
2. Do not remove any safety equipment, belt guards,
or shortcut controls or operations.
3. Make sure drums and rotors are properly and
squarely mounted before starting lathe, and that all
parts are secure.
4. Do not wear loose clothing, jewelry, or gloves
when operating or working around a lathe.
5. Do not overload the lathe. Read and understand
the lathe specifications. Overloading is poor machine
tool practice, shortens the life of the lathe, and could
cause a failure resulting in personal injury.
WARNING
Failure to follow danger, warning, and caution
instructions may lead to serious personal
injury or death to operator or bystander or
damage to property. Do not operate this
machine until you read and understand all
the dangers, warnings and cautions in this
manual. For additional copies of either, or
further information, contact:
Hennessy Industries, Inc.
1601 JP Hennessy Drive
LaVergne, TN 37086-3565
(615) 641-7533 or (800) 688-6359
www.ammcoats.com
CAUTION
Prevent accidents and injury,read and
follow instructions.
1. Read and follow instructions.
2. Always wear eye protection, avoid loose
clothing and jewelry.
3. Keep all guards, shields, and covers in place
and in working order.
4. Keep bystanders out of work area.
5. Unplug unit from power source before ser-
vicing or adjusting.
6. Maintain unit properly, keep work surfaces
and work area clean.