Autoquip FREIGHTLIFT FLH - Manual (Page 13)

13
NOTICE
Protect cylinder rods, hydraulic ports and lines at all times! Welding
splatter and dust from grinding operations can cause severe damage to
this equipment.
NOTICE
Do not damage the pump or motor! If the motor needs to run during the
installation process and the electrical work is not complete, only do so for a
second or two after the mechanical stop is pressed. Longer activation
could cause damage to the pump or the motor. If the electrical control
system is complete, the motor will stop because of the pressure switch
setting.
NOTICE
Cables must be seated before raising lift! Be sure the cables are
seated in the load sheaves above the platform carriage prior to raising the
lift.
SAFETY PRACTICES