Barranca Diamond MK-5005S Block Saw - Manual (Page 20)

20
This method is preferred when cutting small objects.
(A)
Lower the Cutting Head until the
blade is just off the surface of
the movable Cutting Table
(B)
Set masonry piece
in position
(C)
Turn the motor ON
cutting with the cutting Head Positioned Down
MK-5005S oPERaTIoN
chop cutting
A Chop Cut is performed by cutting completely through an object in one pass.
(A)
Adjust the height of the Cutting
Head as necessary, start motor
(C)
Hold the Cutting Table
stationary. Lower Cutting
Head smoothly to cut
(B)
Open the Cooling Flow Control
Valve and adjust flow. Verify
proper cooling flow on both
sides of the blade
(D)
Continue lowering Cutting Head
until cut is complete. Turn the
saw off when work is complete