BASELINE 225 - Manual (Page 10)

6 • Important: Always read and follow instructions.
Principle Operating Parts
Know Your Unit
Compare this illustration with the unit before placing
it into service. Maximum performance and safety will
be obtained only when all persons using the unit are
fully trained in its parts and operation. Each user should
learn the function and location, of all controls.
Prevent accidents and injuries by ensuring the unit is
properly installed, operated and maintained.
❶ ❶ Control Panel
❷ Plug (back of machine)
❸ ON/OFF Switch
❹ Weight Tray with Pockets for Tape-A-Weight
Boxes; Individual Weights
❺ ❺ Wheel Guard
❻ Offset Arm, Measures A & D of Tire/Wheel
(shown in home position)
❼ 40 mm Shaft
❽ Positioning Pedal
Note: Throughout this manual wheel weights are
referred to as Clip-on or Tape-A-Weight®. Figure 5
shows an example of each weight.
Figure 5 - Corrective Weight Examples. For Best Results, use
BADA® Brand Wheel Weights.
Power Switch
The ON/OFF switch location is on the side of the
balancer; below the weight tray. After the beep and the
lamp test, the machine is ready to receive the wheel
data.
Figure 6 - On/Off Switch
Clip-on Weight Tape-A-Weight ®
❶ ❶
❷
❸
❹
❺ ❺
❼
❽
❻
ON/OFF
Power
Switch