BASELINE 225 User Manual
Page 13
Important: Always read and follow instructions.
• 9
Standard Front Cone Mounting
A wheel should be centered by the outer side of the
hub only when the inner surface will not provide an
accurate surface to center on.
Figure 9 - Front Cone Mounting
1.
Select the cone that best fits the center hole in
the wheel.
2.
Lift the wheel onto the shaft and slide it back
against the shaft faceplate.
3.
Slide the cone onto the shaft and into the center of
the wheel. You will need to lift the tire to seat the cone
in the center hole.
4.
Install the hub nut (without pressure cup) onto the
shaft. Tighten it securely against the cone. The hub nut
must engage the threads for at least three full turns.
Note: If the hub nut will not tighten completely
because of a lack of threads, use an additional cone as
a spacer between the mounting cone and the hub nut.
The wheel must be forced firmly against the faceplate.