BASELINE 225 - Manual (Page 11)

Important: Always read and follow instructions. • 7
Offset Arm
In Home
Position
Using The Offset Arm
When not in use store the offset arm in the home
position as shown in figure 7.
Figure 7 - Offset Arm Stored In Home Position
Control Panel
A A
Inboard Plane Display (left)
B B
Outboard Plane Display (right)
C C
Inboard Plane Position Indicator
D D
Outboard Plane Position Indicator
E E
Keys and LEDs for Selecting and Displaying
Available Programs
F F
Key and LED for Selecting Round Off Mode
and Units
G G
Key for Input of Wheel Data
Rounding
When the machine is switched on, its default setting
is to show the unbalance to the nearest five grams
(rounding up or down as necessary) or to the nearest
1/4 ounce if data output in ounces has been set. In this
default setting, the first 4 grams are not displayed since
they are regarded as below the operational threshold
(the “Thr”LED will turn off) and the unbalance will be
shown to the last gram (or to the last 1/10 of an ounce
if this display made is active).
Each time the is press, the machine toggles
between threshold ON and threshold OFF.
Ounce/Gram
Note: By pressing the and holding it down for
about five seconds, you can set up the machine to dis-
play out of balance values in grams or ounces.
Wheel Guard
CAUTION
Never raise up the wheel guard before the
wheel has come to a stop. Keep hair, loose
clothing, fingers and all parts of body away
from moving parts.
If, due to a fault in the machine, the wheel keeps spin-
ning permanently, switch off the machine at the master
switch or by unplugging the plug from the power supply.
Wait until the wheel stops, or actuate the positioning
pedal before opening the wheel guard.
Positioning Pedal
CAUTION
Do not actuate the positioning pedal during
the measurement cycle. Do not use the posi-
tioning pedal as a brake.
After the machine has completed its spin cycle, use
the positioning pedal to hold the wheel position during
weight application. When you press the pedal with your
foot, the spindle shaft is locked.
If you have to brake the wheel in an emergency situa-
tion, while it is being spun by the motor, first disconnect
the power to disengage the motor and then use the
positioning pedal.
Auto Stop Feature
When the wheel is spun and out of balance measure-
ments are displayed, the balancer’s auto stop feature
stops the wheel automatically at the corrective weight
location (12 o’clock).