BKI COq Convection Oven - Manual (Page 29)

Convection Oven Component Replacement
27
Temperature Probe
1. Disconnect the oven power supply by turning
OFF the circuit breaker in the power supply
service panel.
2. Remove the side panel from the control side of
the oven.
3. Loosen probe clamp retaining screw and slide
probe out of clamp.
4. Remove probe wires from the connector by
inserting a 1/8” [3 mm] flat screwdriver into the
release slots as shown. Insert wires from the
replacement probe into the connector in the
same manner. Probe is not polarized so it does
not matter which color wire is inserted into the
connector sections.
5. Insert the replacement probe into the clamp.
The replacement probe must protrude into the
cavity 5/8” [16 mm] as shown. Tighten the
retaining screw. Neatly coil the excess lead
length from the probe and tie wrap it so it does
not contact other oven components.
6. Reattach the side panel to the oven and turn
the power supply to the oven ON.
Pushbutton Switch Contact Blocks
1. Disconnect the oven power supply by turning OFF the
circuit breaker in the power supply service panel.
2. Remove the side panel from the control side of the oven.
3. Release the contact block mount from the pushbutton
operator by depressing the release cam.
4. Move the contact block(s) and mount to an accessible
position. Loosen the terminal retaining screws and
remove the wires from the contact block.
5. Remove contact block from mount by inserting a flat
screwdriver into the retaining clip on one side of the
contact block and prying up.
6. Snap replacement contact block into place on the mount.
Connect wires to replacement contact block.
7. Slide contact block mount back into position on the
pushbutton operator. Push the contact block mount in
until it snaps into place.
8. Reattach the side panel to the oven and turn the power
supply to the oven ON.