BKI DR-34 Double Revolving Oven - Manual (Page 15)

Double Revolving Oven Maintenance
13
Planet Gear Lubrication
Lubricating the Planet Gears with BKI lubricant each day after cleaning will prevent motor damage and
warping of the rotor assembly.
1. Open the operator side door.
2. Lift the passive side rotor assembly off the shaft seat and out of the oven.
3. Wash the passive side rotor assembly with a mild grease cutting detergent and dry with a soft
cloth.
4. Slide the drive side rotor assembly off the rotor shaft and remove from oven.
5. Wash the drive side rotor assembly with a mild grease cutting detergent and dry with a soft cloth.
6. Apply a thin film of BKI lubricant to each planet gear on the drive side rotor assembly.
7. Slide the drive side rotor assembly on to the rotor shaft ensuring that the planet gears properly
align with the sun gear.
8. Place the passive side rotor assembly on the shaft seat inside the oven.
Troubleshooting
Refer to the table below for troubleshooting information. Additional troubleshooting information can be
found on our website at
http://www.bkideas.com/ .
Problem Cause Possible Solution
Unit will not turn on Power to unit is not on. Problem
with building power panel,
circuit breaker or fuse. Check circuit breaker or fuses at
building power panel. If problem
persists, contact an authorized
BKI service agent for corrective
action.
Blown fuse on unit. Contact an authorized BKI service
agent for corrective action.
Defective power switch. Contact an authorized BKI service
agent for corrective action.
Unit operates for a period of
time, then, the control turns off
(no display). Inlet to cooling fan has been
blocked, loss of power to
cooling fan or defective cooling
fan. Remove blockage from around
cooling fan inlet. If problem
persists, contact an authorized
BKI service agent for corrective
action.
Oven does not heat at all. Improper control settings. Reset the control.
Loose wire on heater circuit. Contact an authorized BKI service
agent for corrective action.
Defective relay. Contact an authorized BKI service
agent for corrective action.
Heating elements not
functioning. Contact an authorized BKI service
agent for corrective action.