BKI FW-15DTO Fry Warmer - Manual (Page 11)

Fry Warmer Installation
9
8. Position main unit on WB31211900.
9. Fit pan insert to main unit by lifting the open side of pan insert over the two tabs on main unit and lower
the pan insert into the opening in the countertop.
FW-15T/FW-15DTO (Bottom Breather)
Countertop Collar Weldment With Liner Pan (WB31217700)
1. Obtain a suitable countertop location for the unit.
2. Cut holes in the countertop for the countertop collar weldment with liner pan (WB31217700) according to
illustration below:
3. Using a 1/8” drill bit, drill holes in the countertop used to secure WB31217700 to the countertop.
4. Secure WB31217700 to countertop with # 8 sheet metal screws.
5. Seal WB31217700 to the countertop to conform to NSF Standard 4, Item 4.28. (Dow Corning RTV #732
Multi purpose Sealant.)
6. Feed power cord (supplied), up through holes in WB31217700.
7. Connect wires of power cord to power entry terminal block according to the wiring diagram attached to
the unit or provided in the Service Manual.
8. Position main unit on WB31217700.
9. Fit pan insert to main unit by lifting the open side of pan insert over the two tabs on main unit and lower
the pan insert into the opening in the WB31217700.