Carlin 702GAS Inst Manual User Manual
Page 2
Model 702GAS Advanced gas burners — Instruction manual
Carlin part number MN702G Rev. 03/14/11
– 2 –
Where appliance instructions differ from this manual, follow the appliance instructions.
Contents
PLEASE read this first .............................................................2
General information ................................................................3
1. The Carlin Model 702GAS gas burner ................................4
2. Prepare site • assemble burner • mount burner ......6
3. Install gas piping .............................................................12
4. Wire the burner ................................................................14
6. Checkout procedure — before starting the burner .........16
7. Set burner initial head and damper positions .................17
8. Adjust the burner using test instruments ........................18
9. Maintenance and service procedures .............................22
10. Repair parts ...................................................................24
11. Dimensions ....................................................................28
User care and maintenance .................................... Rear cover
PLEASE read this first . . .
Special attention flags . . .
Please pay particular attention to the following when you see them through-
out this manual.
Notifies you of hazards that WILL cause severe personal injury,
death or substantial property damage.
Notifies you of hazards that CAN cause severe personal injury,
death or substantial property damage.
Notifies you of hazards that WILL or CAN cause minor personal
injury or property damage.
Notifies you of special instructions on installation, operation or
maintenance that are important, but are not normally related
to injury or property damage hazards.
Before installing or
servicing:
Should overheating occur:
(1) Shut off the gas supply to the burner.
(2)
Do not shut off the control switch to the boiler
circulator or the burner.
Follow the guidelines below to avoid potential severe
personal injury, death or substantial property dam-
age.
Installer/service technician . . .
•
Read all instructions before proceeding. Perform all procedures,
and in the order given to avoid potential of severe personal injury,
death or substantial property damage.
•
Before leaving the site after startup or service, review the User
care and maintenance page with the user. Make the user aware of
all potential hazards and perform the training outlined below.
Installer/service technician —
Train the user . . .
•
To properly operate the burner/appliance per this manual and the
appliance instructions. See User care and maintenance.
•
To keep this manual at or near the burner/appliance for ready
access by the user and service technician.
•
To contact the service technician if he encounters problems with
the burner/appliance.
•
To keep the appliance space free of flammable liquids or vapors
and other combustible materials.
•
To never use laundry products, paints, varnishes or other chemicals
in the room occupied by the burner/appliance.
•
To contact the service technician at least annually for startup and
burner/appliance service.
When servicing the burner . . .
•
DISCONNECT ELECTRICAL SUPPLY and all other electrical con-
nections to burner before attempting to service to avoid electrical
shock or possible injury from moving parts.
•
CLOSE all manual gas valves before disconnecting any portion
of gas lines and before cleaning or removing any parts from the
burner or related equipment.
•
Burner and appliance components can be extremely hot. Allow
all parts to cool before attempting to handle or service to avoid
potential of severe burns.