Carter-Hoffmann MDPM4 - Manual (Page 5)

5
Location
For proper operation and maximum performance, locate the cabinet
in an ambient air temperature of 70º F (21ºC).
Avoid areas near exhaust fans where there is active air movement.
For safe operation, locate the unit a reasonable distance from com-
bustible walls and materials.
To prevent injury and damage, locate the unit at a proper and safe
working height. The location should be level, clean of debris, and
strong enough to support the weight of a fully loaded unit.
To prevent electrical shock, be sure unit is unplugged from an elec-
trical outlet. If unit has been operated, allow unit to cool before in-
stalling.
INSTALLATION & START-UP
GROUNDING INSTRUCTIONS
This appliance is equipped with a cord having a grounding wire with
a grounding plug which must be plugged into an outlet that is prop-
erly installed and grounded. In the event of an electrical short cir-
cuit, grounding reduces the risk of electric shock by providing an
escape wire for the electric current.
WARNING—Improper use of the grounding can result in a risk
of electric shock. Consult a qualified electrician or serviceman if
the grounding instructions are not completely understood, or if doubt
exists as to whether the appliance is properly grounded.
IMPORTANT:
Power cord is 6' long.
If necessary, contact a
licensed electrician to install an ap-
propriate electrical circuit with cor-
rect receptacle.
DO NOT use an extension cord.
WARNING:
Risk of personal injury
Installation procedures must be
performed by a qualified technician
with full knowledge of all applicable
electrical codes.
Failure can result in personal injury
and property damage.
CAUTION:
Risk of personal injury
Unit is not waterproof, to avoid
electrical shock keep unit and
counter from being submerged in
water. Do not operate if unit has
been submerged in water.
CAUTION:
Electrical Shock Hazard
The ground prong of the power cord
is part of a system designed to pro-
tect you from electric shock in the
event of internal damage.
DO NOT cut off the large round
ground prong or twist a blade to fit
an existing receptacle.
Start-up
1. Plug the cabinet into a properly grounded electrical receptacle.
2. Ensure all plastic and packaging materials have been removed.
3. Set POWER switch to “ON” position.
4. Do not load product into the cabinet. Allow the heat to remove
any residual oils which may adhere to inside metal surfaces. A
slight emission of smoke is normal for the first few hours of
operation.
5. Appliance is preset at the factory. However, the temperature is
adjustable. See page 7 for programming instructions.
IMPORTANT:
Not under warranty:
Damage to unit due to being
connected to the wrong voltage or
phase is NOT covered by warranty.