Carter-Hoffmann SR1820 - Manual (Page 6)

6
INSTALLATION & STARTUP
Unpack the cabinet. Ensure that all packing materials and
protective plastic has been removed from the unit. Inspect all
components for completeness and condition.
For safe operation and maximum performance, located the
unit at least 2” from any wall or combustible material.
Install tray slides at 3.5” spacing (every other notch). Tabs on
each end of the slides will fit into notches on side wall baffles.
Simply angle the slide so that the top of each tab slides into
the notch; then turn the slide to level position. NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it for
proper operation.
Refer to FREIGHT DAMAGE
CLAIM PROCEDURE on PAGE 5
of this manual.
WARNING:
Risk of
personal injury
Installation procedures must
be performed by a qualified
technician with full knowledge of
all applicable electrical codes.
Failure can result in personal
injury and property damage.
CAUTION:
Electrical Shock Hazard
The ground prong of the
power cord is part of a system
designed to protect you from elec-
tric shock in the event of internal
damage. DO NOT cut off the large
round ground prong or twist a
blade to fit an existing receptacle.
IMPORTANT:
Power cord is 10' long.
If necessary, contact a licensed
electrician to install an appropriate
20 amp electrical circuit with
NEMA 5-20R receptacle. DO
NOT use an extension cord.
IMPORTANT:
Damage to unit due to being con-
nected to the wrong voltage or
phase is NOT covered by war-
ranty.
GROUNDING INSTRUCTIONS
This appliance is equipped with a cord having a grounding
wire with a grounding plug which must be plugged into an
outlet that is properly installed and grounded. In the event of
an electrical short circuit, grounding reduces the risk of elec-
tric shock by providing an escape wire for the electric current.
WARNING—Improper use of the grounding can result in
a risk of electric shock. Consult a qualified electrician or
service agent if the grounding instructions are not completely
understood, or if doubt exists as to whether the appliance is
properly grounded.
START UP
Appliance should be thoroughly cleaned before use. See
CLEANING INSTRUCTIONS, page 8.
1. Familiarize yourself with the controls. Plug the power
cord of the cabinet into a properly grounded NEMA 5-20R
electrical receptacle according to the electrical informa-
tion provided below. DO NOT MODIFY CORD PLUG.
2. Set POWER switch to the “ON” position.
3. Do not load product into the cabinet. Allow the heat to
remove any residual oils which may adhere to inside
metal surfaces. A slight emission of smoke is common
during the first few hours of operation.
Volts : 120
Watts: 1500
Amps: 12.5