Beltronics 980 - Manual (Page 21)

Conditions that Affect Laser Alerts
If you feel your unit is not properly alerting to the presence of
Laser signals, keep in mind that rain, fog, high humidity and
traffic conditions can affect the range that the Laser beam can
be detected.
t rouble sh o ot i n g
Solutions for Common Problems
If your unit is not operating properly, please refer to the
outline below.
Problem Possible Cause Corrective Procedure
Unit not Plug not properly inserted Reinsert plug and rotate
receiving power
Fuse in power cord is Replace with 1 amp
defective 250 Volt 3ag fuse (see page 14)
Lighter socket not clean Consult your dealer or a
and negatively grounded professional mechanic
Fuse or electrical wiring Consult your dealer or a
for lighter socket defective professional mechanic
“Poor detection Antenna/lens opening Reposition unit with
range” partially blocked unobstructed view of
road ahead and behind.
Radar signals unable to Determine whether
pass through windshield your vehicle has a
“heated windshield”
known as Instaclear
®
or ElectriClear ® , or
is covered with a
metallic sun screen.
Erratic or frequent High concentration of Use cty mode
alerts non-police X band sources or cty all
Review section in this
manual on Performance
Verification
Partial or no display Dim or dark mode engaged Disengage dim or
dark mode
If you experience a problem with your unit that is not covered
in this outline please call, Monday to Friday, 8:30 am–4:30 pm
est
, for assistance:
1-800-341-2288 usa 1-800-268-3994 canada
