COATS 6200HS Truck Wheel Balancer - Manual (Page 35)

Operation Guide
29
F. Spinning wheel by hand - ‘EEE’ is reported.
The wheel may have been spun in the wrong direction
(anti-clockwise when facing the outer rim), or the wheel
has been spun up to measuring speed (the balancer
beeps once) and then slowed, or stopped, before the
balancing cycle is completed.
Re-spin the wheel, spinning it in the correct
direction (clockwise when facing the outer rim).
Ensure that the wheel is mounted properly and
that the Hub Nut is securely tightening the wheel
against the flange; the wheel must not slip on
the shaft.
Check that wheel movement is not being
impeded.
When only a wheel rim is mounted, the rim may
be too light to maintain speed; try spinning the
rim a little faster.
G. Balancer beeps continuously.
The wheel has been spun too fast by hand and is
spinning above the measurement speed range, or
there may be a fault in the electronics assembly.
Wait until the wheel slows to a speed within the
required range or carefully slow the wheel. The
balancer will no longer beep when the wheel
spins at the correct measuring speed, and will
continue with the balancing cycle.
If the balancer continues to beep even when
the wheel is slowed or stopped, then the
balancer should be switched off. Wait a few
seconds and then turn on the power again.
H. The decimal point is constantly displayed.
The balancer is set to display weight units in ounces,
or the display electronics are faulty.
To change weight units, press Hidden button and
then press Fine on the input panel. Hold both
pressed for 3 seconds. The balancer will beep
and the decimal point will be turned off.
If this does not work, the electronics assembly
should be replaced.