COATS 6200HS Truck Wheel Balancer User Manual
Page 27
Operation Guide
21
Front Cone Mounting with an Extension
Adaptor
The extension adaptor may be required for some light
truck wheels and reverse-offset wheels that must be
moved away from the balancer mounting flange. The
extension adaptor is often used with the 5-
1
/
2
-inch
diameter light truck cone.
Install the extension adaptor on the mounting flange
with the knurled thumbnuts provided. Then mount the
wheel, using the normal front cone method.
Universal Wheel Adaptor
This adaptor is used on wheels with untrue center holes
and wheels with closed center or for any application
where automotive mounting cones can not be used.
Instructions for use are supplied with the adaptor.
Metric Bolt Plate Adaptor
The metric bolt plate adaptor is an alternative to the
universal wheel adaptor. The adaptor is used on wheels
with untrue center holes, wheels with closed center
holes as found on many French vehicles, or where the
wheel is centered on the wheel mounting studs rather
than by conical wheel mounting nuts. Instructions for
use are supplied with the adaptor.