COATS Vero Series Wheel Balancer - Manual (Page 13)

Important: Always read and follow instructions. • 7
Important: The A2 measurement must be at least 2
inches greater than the A1 measurement.
Figure 9B - T2 Tape (Hidden Tape-A-Weight®), Keep At Least 2
inches Between A1 and A2 Measurement
Figure 9C - T2 Tape (Hidden Tape-A-Weight®), Data Entry
Diagram
Using The Laser Locator
If the T2 Tape (hidden Tape-A-Weight®) location is
selected, use the laser locator to point to the hidden
weight location (figures 10 & 9B). Rotate laser locator
knob to position the laser dot outboard at the desired
T2 Tape (hidden Tape-A-Weight®) location.
Note: For best performance, choose a weight position
outboard as far inward (in the rim) as wheel allows.
Figure 10 - Positioning Laser Dot At T2 Tape Hidden Weight
Location (A2)
Note: The T2 Tape Direct Select™ Weight position is
the only mode that requires the A2 & D2 dimension
measurements.
Using The Line Laser
If the T2 Tape (hidden Tape-A-Weight®) location is
selected, use the line laser to align the offset arm with
the laser locator dot (figures 10 & 9B); entering A2 &
D2 measurements automatically. Grasp arm at the line
laser and pull out and up to the wheel flange (figure
8B). Hold arm still at the clip-on weight location and
wait for BEEP. Then, before returning arm to home posi-
tion, press button on line laser to activate the line laser
beam. Move arm to inner area of wheel and align line
laser beam with laser locator dot (figure 10). Hold arm
still, up against the rim, in the same plane as the T2 Tape
(hidden Tape-A-Weight®) location (figure 9A & 9B) and
wait for BEEP. Refer to figure 11.
Note: The line laser remains on for ten seconds after
its button is pushed.
Figure 11 - Positioning Line Laser Beam At T2 Tape Hidden
Weight Location (A2)
At least
2-inch
minimum
difference
A1 A2 Laser
Locator
Knob
Laser
Locator
Dot
Center Line
Laser Beam on
Laser Locator
Dot
Press Line
Laser Button