COATS Vero Series Wheel Balancer User Manual
Page 16
10 •
Important: Always read and follow instructions.
Touchscreen Layout
Figure 15 - Model V200 Default Touchscreen Feature Reference
1
1
2
2
2
2
3
3
3
3
5
5
8
8
7
7
6
6
8
8
6
6
4
4
4
4
3
3
7
7
5
5
7
7
Figure 15 Model V200 Default Touchscreen Feature Reference
Touchscreen User Interface (UI) Function and Review
1
1
Information / Instruction Panel
An information box appears when the operator text assist icon is activated and to display any error
messages.
2
2
Weight Display Dials
Located on either side of the wheel cross-section diagram are the weight position bars, one Inboard
and one Outboard. After a measurement cycle, rotate wheel until the center weight position bar blinks,
indicating the correct weight placement position is at top-dead-center.
3
3
Direct Select™ Weight Location Icons & Cross-section Diagram
or
Clip 1 or T1 Tape
The activated Inboard weight location on the wheel
cross-section diagram.
,
, or
T2 Tape, T3 Tape, or Clip 2 The activated Outboard weight location on the wheel
cross-section diagram.
Direct Select™ Weight
Location
Select to go to the Direct Select Weight Location
Screen, see page 14.
4
4
Weight Position Bars
Located on either side of the wheel cross-section diagram are the weight position bars, one Inboard
and one Outboard. After a measurement cycle, rotate wheel until the center weight position bar blinks
green, indicating the correct weight placement position is at top-dead-center. When in laser mode (T2
Tape Laser Locator), special blinking bars appear on either side of the center bar to indicate the correct
outboard weight placement position. Also remember that the laser beam dot will stop blinking when it
is at the correct weight placement location.