COATS CDH-4730 Electric-Hydraulic Tire Changer - Manual (Page 3)


1. INTRODUCTION
Thank you for purchasing one of our tIre-changers: This label has been specifically designed to fit and remove truck, bus and commercial vehicle
tires, with rims from 14” to 26” and maximum 47” (1200 mm) diameter. Any other use is improper and therefore not authorized.
The machine has been constructed to the best quality principles.
This manual has been made in order to supply the owner as well as the user with the basic instructions for a correct use of the tire-changer.
That’s the only way to grant the respect of the conditions necessary to work safely and also grant the best efficiency and a long life to the machine.
Read this manual with the utmost care before using the tire-changer.
Keep this manual as well as all the supplied technical literature in a safe place close to the tire-changer so as to help the users to consult it whene-
ver necessary.
The technical literature is an integral part of the machine and it must always follow the product, during it’s entire life
These instructions are intended for trained users and professionals, having a certain level of knowledge in the matter. We have therefore avoided
to describe each single operation. Always avoid to carry out operation beyond your own cability. In case of any need of assistance, your service.
Follow the directions given by this guide carefully.
Any other use not described is to be considered as
improper and irrational, and thus it will be under the
whole responsibility of the operator.
The manufacturer shall not be liable for any injury to persons or damage to things caused by improper use of this machine.
1.1. Technical data