COATS HIT 5000H2 Truck Tire Changer - Manual (Page 15)

H.I.T. 5000H2
COATS H.I.T. 5000H2 Changer • 9
11. Using table cylinder, press tire and inner tire
down off of rim.
12. Remove compressor and rim from table top.
13. Rotate table to horizontal position and remove
inner and outer tire from table.
14. Roll tire onto carriage platform and clamp bead
into deepest "V" in jaws.
The hydraulic pressure regulator knob,
located on the swinging pod front, should
be set at minimum pressure. Also, care
should be taken to ensure that the beads
are not overly stretched.
15. Using the longest of the two nylon web straps,
place the strap around the top of the inner tire and the
cross brace of the table linkage. The carriage should be
in the retracted position. Using socket and ratchet,
tighten strap as shown.
Note: The vertical cylinder should be lowered to a
point where the tire just clears the carriage.
16. Move the carriage to the extended position,
thus pulling the inner tire out of the outer tire. If the
two tires are not separated when the carriage has
reached its extended position, further travel can be
reached by raising the vertical cylinder until the two
tires are separated.
17. Remove the web strap from the inner tire, and
remove the outer tire from the clamps of the machine.
CAUTION