COATS HIT 5000H2 Truck Tire Changer - Manual (Page 6)

vi • COATS H.I.T. 5000H2 Changer
H.I.T. 5000H2
Installation
It is not necessary to bolt the H.I.T. 5000H2 to the
floor. However, if desired, use the holes provided in
the base of the machine.
Most electrical codes require machinery
that is permanently installed to be wired
directly to the power source via conduit.
Remove the H.I.T. 5000H2 from the shipping pallet
and position on a relatively level and smooth floor,
preferably concrete.
Important: Read this operators manual thoroughly
before attempting to change any tires. Also, actuate
the controls several times to become familiar with
their function and direction.
Electric Installation
The H.I.T. 5000H2 requires 220 volts, 60 cycle, single
phase power, with a 20 amp circuit. An optional model
is available for 110 volt, single phase.
Important: Have a licensed electrician connect the
H.I.T. 5000H2 to the power source. The licensed elec-
trician must sign the warranty registration card to val-
idate the warranty.
CAUTION