COATS HIT 5000H2 Truck Tire Changer - Manual (Page 19)

H.I.T. 5000H2
COATS H.I.T. 5000H2 Changer • 13
Extended Service Kit Items
Hennessy Model 8090011 (GM 10603931) - H.I.T.
5000H2 Tire changer with extended kit.
Hennessy Kit 183970 (GM 10603930) - Extended
service kit ordered separately.
Item Part
No. No. Qty. Description
1 183959 1 Wing Set, LAV-III
2 183971 1 End Plate, LAV-III
3 183972 1 4" Strap & Buckle Assembly
4 183967 1 Spreader-Straight, LAV-III
5 184125 1 Screwdriver, KD Tool
6 184047 1 Yoke, Ram Extension
7 109626 1 Locking Pin, Cylinder Extension
8 110852 1 Offset Roller
110829 3 Clamp Jaws, #183970 Kit only (not
shown)
Note: Due to a design change, be sure to replace the
jaws on a H.I.T. 5000H model older than 1993. New
jaws are supplied in the 183970 kit. Also, replace the
jaws on a 1993 or newer production H.I.T. 5000H
model only if the ones on the machine are worn.
Demounting
1. Place the support table over the ram at the end of
the machine with the center shaft upward. Extend the
ram slightly to keep it in place.
2. Install the ram extension yoke, locking it and the
plate in position with the extra clevis pin.
3. Extend the carriage, moving the end plate into a
vertical position.
4. Stand the wheel upright and walk it into place,
against the end plate, with the wheel bolts facing out-
ward.
5. With another person holding the wheel in place,
move the carriage in, bringing the end plate and wheel
up into a horizontal position.
ALWAYS be aware of what each person is
and will do before attempting any two-per-
son operation.
WARNING
Hutchinson LAV-III Military Tire
Ẇ
ẇ
Ẉ
ẉ
Ẋ
ẋ
Ẅ
ẅ