COATS HIT 5000H2 Truck Tire Changer - Manual (Page 18)

21. Remove compressor and retaining ring.
22. Place rim seal down around rim and under bead.
23. Place retaining ring, and lock ring, on top of tire.
24. Install compressor onto clevis affixed to rod end
of table cylinder.
25. Press retaining ring down on rim seal and outer
tire bead down below lock ring groove.
26. Install lock ring and insure that it is down prop-
erly in lock ring groove.
27. Raise table cylinder and remove compressor.
28. Extend carriage cylinder rotating table to hori-
zontal position.
29. Remove mounted tire from machine.
ALWAYS follow all applicable Local, State, and Federal
Codes, Rules, and Regulations; such as the Federal
OSHA Standard Number 1910.177.
NEVER seat beads or inflate a tire on the tire changer.
The H.I.T. 5000H2 is not designed as a safety device or
stand for bead seating or inflation.
ALWAYS use an approved inflation chamber or infla-
tion cage.
Tire failure under pressure can be haz-
ardous. Place the wheel inside an approved
inflation chamber or cage before inflating.
Use an approved remote inflation valve,
hose, and gauge. ALWAYS wear safety gog-
gles for eye protection. Do not stand beside
the wheel or cage during inflation. Keep
hands and other parts of the body out of the
cage during inflation. Observe the tire pres-
sure frequently. Do not exceed the manufac-
turer's recommended maximum inflation
pressure. Failure to follow these instruc-
tions may cause the tire and rim to separate
with tremendous force, resulting in serious
personal injury or death.
DANGER
H.I.T. 5000H2
12 • COATS H.I.T. 5000H2 Changer