COATS Kit 85606689 Leverless Bead Lifter - Manual (Page 4)

4 • Important: Always read and follow the instructions.
6. Lock the vertical slide shaft and then remove the
mount/demount head, Duckhead® roller mount and
rubber cushion.
7. Hold vertical slide shaft down, release lock handle
and remove shaft assembly out the top. Note orienta-
tion of flat on the end of shaft.
Note: On units equipped with shoulder screw, use
shim for plastic mount/demount head vertical bar lock.
8. Remove spring, install short spring from kit and
place shaft assembly back into swing arm. Reassemble
with shaft flat in same orientation.
9. Lock shaft.
10. Attach adapter to leverless bead lifter mount/
demount head so that the (2) set screws line up with
the adapter flat. Snug (1) set screw on side to hold
adapter in place.
11. Assemble washer set on screw, small washer
first with mating bevels together. Attach leverless bead
lifter assembly to vertical shaft; hand-tight only.
12. Connect coil air hose from leverless bead lifter to
the fitting installed on top of swing arm bracket (from
step 5).
13. Re-connect air supply to machine. Inspect and
correct leaks if found.
14. Be sure to perform the steps for the Leverless
Bead Lifter Adjustment Procedure on page 7.
Align Set Screws
With Adapter Flat
Connect Coil Hose
To Fitting
Remove Mount/
Demount Head
Attach Leverless
Bead Lifter To Shaft
Hold Shaft Down
And Release Lock