COATS Kit 85606689 Leverless Bead Lifter - Manual (Page 7)

Important: Always read and follow the instructions. • 7
Leverless Bead Lifter
Adjustment Procedure
1. Use a 17-inch diameter wheel for adjustments.
This covers the normal range of 14 to 21-inch wheels.
2. Set mount/demount head to 1/8 to 3/16-inch
above wheel.
3. Align mount/demount head to match curvature of
wheel.
4. Snug (2) set screws in adapter. Then snug (2) set
screws in mount/demount head making sure mount/
demount head to wheel relationship doesn’t change.
5. Loosen (2) set screws on adapter 1/4 turn.
6. Tighten screw holding leverless bead lifter assem-
bly to vertical shaft; torque to 20-26 ft-lbs.
7. Tighten set screws (4) — (2) on adapter and (2) on
mount/demount head.
8. Tighten (1) set screw on side of mount/demount
head
9. Tighten (1) set screw through access hole on
leverless bead lifter.
1/8" to 3/16"
(2) Adapter
Set Screws
(2) Mount/Demount
Head Set Screws
Torque To
20-26 ft-lbs.
Tighten Set
Screw
Align Mount/
Demount Head
With Wheel
Curature