COATS Kit 85606689 Leverless Bead Lifter - Manual (Page 6)

6 • Important: Always read and follow the instructions.
9024 Series Installation
1. Lower vertical slide shaft about 9-inches. and lock
bar. Tighten hex screw to lock bar.
2. Disconnect the electrical power, close the air lever
cock and bleed the air circuit completely.
3. Release hex screw of pipe locking knob. Insert kit
spring and hex washer and tighten hex screw back on.
4. Cut the black hose, as in picture, and insert the
union delivered with the kit.
5. Place the plate, complete with unions, on the
locking plate screw. Attach nut and tighten. Then insert
hose into the L-shaped union.
6. Insert the other end of the hose into the T-union
previously installed (step 4).
7. Using two hose clamps from kit, attach the hose
at the end of the guide placed behind the post. Cut the
over length and secure with ties.
8. Remove the mount/demount head. Then release
the tool locking screw using hex wrench. Keep screw
and washers.
9. Next install the leverless bead lifter to the shaft
following the 50/70 series installation step 11.
10. Insert the quick union into the free end of the
coil hose and then insert this quick union into the
female union on the plate (from step 5).
11. Re-connect air supply to machine. Inspect and
correct leaks if found. Open the air lever cock to send
pressure to circuit.
12. Move the bar lock selector to middle position.
You will hear an air bleed.
13. Release the hex bush screw to release the oper-
ating arm.
14. Be sure to perform the steps for the Leverless
Bead Lifter Adjustment Procedure on page 7.
Use Hose
Clamps To
Route Hose
Attach Plate
Install
Union