Condux CableGlider FO Cable Puller - Manual (Page 14)

14
Finish Puller Setup
a. Move the puller into its final position. The pull line will wrap best on the capstan if the capstan is angled
about 10° away from the pull line (figure 18). This will allow the line to walk down the side of the capstan
and push the previous wraps to the side.
b. Place four or more side-by-side wraps of the pull
line around the capstan in the direction of rota-
tion. Do not wrap more than one layer of pull
line on the capstan.
c. Start the hydraulic power source.
Final Inspection
!wARNINg: Before placing the puller into operation, always perform a final inspection of it and all compo-
nents used.
a. The foot control pedal has full range of motion and is in the neutral position.
b. The electronic control box POWER switch is ON.
c. The tension limit is set correctly.
d. The TENSION LIMIT CONTROL is ON, if overload control is required.
f. The chart recorder’s Record Mode has been switch to ON.
g. All safety requirements are met and all people are aware that the unit will be set in motion.
7.
8.
10°
Figure 18. Puller Positioning