Det-Tronics X3301 Multispectrum IR Flame Detector with HART - Manual (Page 14)

95-8577 12 3.1
oi MENU
1) Left oi Percentage of calibrated oi test signal returned by the left sensor. Reading should be 90
to 100 percent. If reading is below 90 percent, go to “Device Setup”, select “Calibration”,
and perform oi Calibration.
2) Middle oi Percentage of calibrated oi test signal returned by the middle sensor. Reading should be
90 to 100 percent. If reading is below 90 percent, go to “Device Setup”, select “Calibration”,
and perform oi Calibration.
3) Right oi Percentage of calibrated oi test signal returned by the right sensor. Reading should be 90
to 100 percent. If reading is below 90 percent, go to “Device Setup”, select “Calibration”,
and perform oi Calibration.
4) oi Fail Count Number of consecutive oi failures counted (one passed oi test resets the counter).
5) No. oi Failures Set (allowable) number of consecutive oi failures to produce a fault.
6) oi Cal Active oi calibration is in progress.
7) oi Cal Fault An oi calibration fault has occurred.
8) Manual oi Active A manual oi test is in progress.
9) Manual oi Fail The detector has failed the last manual oi test.
oi Menu
1) Left oi
2) Middle oi
3) Right oi
4) oi Fail Count
5) No. oi Failures
6) oi Cal Active
7) oi Cal Fault
8) Manual oi Active
9) Manual oi Fail
Device Info Menu
1) General Info Menu
2) HART Info Menu
3) Status Info Menu
4) Detector Settings
5) History Menu
X3301 Root Menu
1) Fire (Yes/No)
2) Fault (Yes/No)
3) Device Info Menu
4) Command Menu
5) Device Setup Menu
Status Info Menu
1) Warmup (Y/N)
2) Fire (Y/N)
3) Auto
oi Fault (Y/N)
4) Dim Detect Fault (Y/N)
5) Detect Disable Flt (Y/N)
6) Snsr Hdwr Fault (Y/N)
7) HIB Hdwr Fault (Y/N)
8) Int Comm Fault
9) Incompatible Flt
10) Voltage Fault (Y/N)
11) Hardware Menu
12)
oi Menu