Elkhart Brass Cobra 7200 EXM Monitor - Manual (Page 12)

12
RF Transceiver in Panel Mount
1
2
 If the Panel Mount will use RF communication, install the
RF Transceiver Module into the controller.
o Remove the back cover from the Panel Mount
Controller using a flathead screwdriver.
o Connect the RF Transceiver with the wires running the
length of the board as shown in the picture to the right.
o Reattach the back cover of the Panel Mount. Ensure no
wires are pinched.
o If the CAN leads will not be used, replace wires with
appropriate plugs.
 Supply power to the controller by connecting plug 2 leads to an appropriate power source.
 Install a 1 Amp fuse into the positive power lead for a 12V system (1/2 Amp for 24V system).
 Refer to the respective plug figures for information on the plugs’ pins.
Handheld Controller and Docking Station –
 Using the Docking Station template shown in the
Component Mounting Templates section, drill all 7/32”
holes shown through the panel intended for mounting
the Docking Station.
 Mount the Docking Station with the supplied 10-24 x
3/8” screws using blue Loctite 242 or equivalent.
Torque screws to 50-60 in-lbs. The screw length allows
for a panel thickness range of 0.046”-0.125”.
 Supply power to the Docking Station by connecting the plug leads shown to an appropriate
unswitched power source.
 Install a 1 Amp fuse into the positive power lead of the Docking Station for a 12V system (1/2
Amp for 24V system).
 Lift the Docking Station top and place the Handheld Controller into the station. Then push the
top down until the contacts connect with the handheld. (see maintenance instructions section B
for LED signals)
 For instructions on converting a Panel Mount Controller to a Handheld Controller, refer to the
steps below.