Elkhart Brass Cobra 7200 EXM Monitor User Manual
Page 27
27
Pressing UP, DOWN, LEFT, RIGHT, or OSCILLATE will stop oscillation of a boxed area (Pressing
LEFT, RIGHT, or OSCILLATE will stop horizontal oscillation while pressing UP, DOWN, or
OSCILLATE will stop vertical oscillation.
o
All other functions can be operated without stopping oscillation.
K. Handheld Controller Sleep / Hibernation Mode
Sleep Mode – The Handheld Controller will go into sleep mode after one minute of inactivity. The
blue power LED will blink every three seconds while in sleep mode. Any button press will wake the
unit up.
Hibernation Mode – After 5 minutes of inactivity the handheld will go into hibernate mode. All
LEDs will be off when the handheld is in hibernate mode. The AUX button is the only button that
must be pressed to turn the handheld on at that point.
o
The handheld can be placed in hibernate mode by pressing and holding the AUX button
until the power LED turns off.
L. Valve Operation
OPEN – opens the valve. If the button is released, the valve will remain in the current position
until another valve operation is performed.
o
In order to initiate auto-travel open, press and hold the OPEN button, then press and release
the CLOSE button, then release the OPEN button. The valve will then auto-travel to fully
open.
CLOSE – closes the valve. If the button is released, the valve will remain in the current position
until another valve operation is performed.
o
In order to initiate auto-travel close, press and hold the CLOSE button, then press and
release the OPEN button, then release the CLOSE button. The valve will then auto-travel to
fully closed.
PRESET – Opens or closes the valve to a preset position
o
To Change Valve Preset, move the valve to the desired position.
o
Press and hold the PRESET button for 10 seconds
o
The PRESET button will now bring the valve into this position when pressed outside of Setup
Mode
TRIGGER (Joystick Only) – When the Joystick TRIGGER is pulled, the valve will begin opening and
stay open as long as the TRIGGER remains pulled. When the TRIGGER is released, the valve will
close.
M. Auxiliary
Turn on/off optional light 1 – Hold AUX and press FOG
Turn on/off optional light 2 – Hold AUX and press STREAM