Elkhart Brass Cobra EXM Light Kit - Manual (Page 2)

2
PREPERATION
NOTE: Before beginning installation of the light kit, turn off power to the EXM monitor.
Tools needed:
You will need the following tools to install the light kit.
 Allen Wrenches: 5/32”, 9/64”, 1/8”
 Slotted (Flat-Head) Screwdriver
 Blue Loctite #242 (or equivalent)
INSTALLATION STEPS
1. Remove the EXM control module by removing the four (4) 8-32 screws that hold it in place. Disconnect
the three (3) plugs from the control module. Store the control module and the four (4) 8-32 screws in
a place where they will not be lost or damaged; they will be used later.
2. Remove and discard the two sets of 10-24 screws and hex nuts from the side of the control module
housing.