Elkhart Brass Cobra EXM Light Kit User Manual
Page 6
Advertising
6
11. Remove the 10-24 button head screw and clamp loop holding the monitor power harness in place.
With the supplied 10-24 round head screw, attach the supplied clamp loop and original clamp
loop as shown. Apply blue Loctite #242 or equivalent to threads.
12. If a light was received with the light kit, mount the light onto the monitor discharge elbow with the
provided ¼”-20 button head screws. Apply blue Loctite #242 or equivalent to the screw threads.
Route the light harness so that it runs in front of the light bracket as shown.
13. Power on the EXM and light kit, and test the operation of the light as outlined in the operation
instructions section below.
Advertising