Elkhart Brass Scorpion RF 8294-07 - Manual (Page 9)

9
Installation Step 2: Communication Address Setup
An RF Controller controls one 8294-07 monitor. The controller is digitally encoded with a security code
ensuring that it does not accidentally control the wrong monitor. The receiver has a matching decoder
and security code that instantly decodes and interprets commands. The security code is a 15-bit
selectable code that is set on both the remote transmitter and receiver.
The 8294-07 monitor is tested and shipped with a security code based upon the monitor serial
number, ensuring each monitor leaves the factory with a unique code assigned to it. The security
settings will normally not need to be changed. In the case of a lost transmitter or replaced control
board, contact Elkhart Brass.
Danger:
Using two W.E.T. monitors with the same security code may cause the
inadvertent control of the wrong monitor, resulting in possible property damage and
injury to personnel. Using the factory specified codes will help prevent this.
Caution:
Do NOT pinch wires when attaching back panel to front panel of the
handheld enclosure. Ensure all O-rings and gaskets are properly installed when closing
the receiver or transmitter enclosures.
Important:
The RF Receiver/Control Module and all transmitter communication
addresses have been factory set. They should not require any additional address setup.