Elkhart Brass SPIT-FIRE 8394053 Monitor - Manual (Page 12)

12
2.1.
Locate the PLC inside the Control Panel enclosure.
2.2.
Locate the user interface.
Fig. 2.2 – User Interface - Default Screen at Power Up
2.3.
Press [OK] and the next screen will appear (Fig. 2.3). This is the monitor position data and will
update as the monitor is moved. This is a read only screen and no data can be entered here.
Fig. 2.3 – Monitor Position Data
3.
Changing the operating data of the monitor: This is the beginning of the menu area that will be accessed
the most due to possible changing of the monitor’s park position and oscillation angle. Complete system
set up data is towards the end of the menu and will be discussed later in this document. If the system is
set up in a ROCP to LOCP to MMCP configuration, the following monitor park position data can be
changed in either the ROCP or LOCP for the panels that have the same Monitor ID number.
3.1.
Press [OK] and the next screen will appear (Fig. 3.1). This is the Horizontal Park Angle position.
Note: The first digit on the right will be flashing; this is where the cursor is.
Fig. 3.1 – Horizontal Park Angle Position Data
RUN
ENTER NEW PARK
HORIZONTAL ANGLE
= +00085
RUN
MONITOR POSITION
VERTICAL = 45
HORIZONTAL = 130
+00085
REMOTE
ELKHART BRASS
INDUSTRIAL EQUIP
MODULAR-A4
ESC
OK
[Up] Key
Increase Value
[Down] Key
Decrease Value
[Left] Key
Move Flashing
Cursor Left
[Right] Key
Move Flashing
Cursor Right
[OK] Key
Enter Value
[Esc] Key
Cancel Change