ElmoMC SimplIQ Analog Servo Amplifiers-Flute Installation - Manual (Page 14)

Flute Installation Guide
MAN-FLUIG (Ver. 2.301)
www.elmomc.com
14
Chapter 3: Installation
3.1. Site Requirements
You can guarantee the safe operation of the Flute by ensuring that it is installed in an
appropriate environment.
Feature Value
Ambient operating temperature 0 °C – 50 °C (32 °F – 122 °F)
Maximum case temperature 87 °C (188 °F)
Note: Models for extended environmental conditions are available.
3.2. Unpacking the Drive Components
Before you begin working with the Flute system, verify that you have all of its components, as
follows:
• The Flute servo drive
• The Composer software and software manual
The Flute is shipped in a cardboard box with Styrofoam protection.
To unpack the Flute:
1. Carefully remove the servo drive from the box and the Styrofoam.
2. Check the drive to ensure that there is no visible damage to the instrument. If any damage
has occurred, report it immediately to the carrier that delivered your drive.
3. To ensure that the Flute you have unpacked is the appropriate type for your requirements,
locate the part number sticker on the side of the Flute. It looks like this:
The P/N number at the top gives the type designation as follows:
FLU-XX/YYY
.
Maximum
Operating
Voltage
Continuous
Output
Current
4. Verify that the Flute type is the one that you ordered, and ensure that the voltage meets
your specific requirements.