ETC Desire D22 - Manual (Page 2)

2 Desire Series D22
Control
Portable
The Portable D22 is provided with 5-pin XLR connectors on the back for in and thru
connection to a DMX/RDM control network.
Canopy Mount
The D22 Canopy Mount fixture is provided with one cable, which provides power
and data into the canopy.
A termination board is incorporated into the mounting plate for installation onto a
voltage-separated junction box (junction box provided by others, voltage barrier
provided by ETC) and provides termination for control wiring.
• Connection of the D22 data cable to a provided screw-down connector,
which is pre-wired at the factory. The connector is plugged into the
termination board. The braided shield is connected inside the fixture and
should not be connected in the canopy.
• Connection of DMX/RDM input from the control source. This connection can
be cable type Belden 9729 (or equivalent) to the provided screw terminal.
When using Cat5 (or equivalent) cable type for DMX/RDM input, order a
Cat5 termination kit from ETC (part number 4100A1013). Cat5 termination
instructions and an IDC connector are provided with the termination kit.
• Connection of DMX/RDM thru to the next DMX device. This connection may
also be either Belden 9729 or Cat5. The connector is not provided. Order the
appropriate DMX termination kit for the cable type used from ETC (Belden
9729 use 4100A1012 or Cat5 use 4100A1013). Termination instructions and
the appropriate connector is provided with the termination kit. Up to 32 DMX/
RDM devices can be daisy-chained together per data run.
Track Mount
The Track Mount fixture’s power and data connections are made through the
Eutrac MultiAdaptor mounting adapter. No further wiring to the fixture is required.
Refer to the track installation instructions for more information.