ETC Desire D22 - Manual (Page 3)

3
Electrical
The Desire D22 Portable is provided with a permanently installed power cord with
3-prong Edison connector. Region specific connectors are available. Contact ETC
for available options. The Canopy fixture is provided with power and data wired to
the canopy and should be terminated in a voltage-separated junction box (provided
by others). The Track mount receives power through its MultiAdaptor, which
connects to one of two circuits.
Power Requirements
The universal power supply accepts 100-240 VAC 50/60Hz.
W A R N I N G : Ensure the main power supply is off before installing or
wiring a fixture.
C A U T I O N : Do not use a fixture for any voltage for which it is not rated. Do
not exceed the specified voltage and current input for any
fixture.Connecting the fixture to a voltage outside the
acceptable range may damage the unit and will void the factory
warranty.
N o t e : The fixture must be grounded.
Application appropriate electrical junction box with cord grips
are required. A voltage-separated junction box is required. A
RACO 232 series 4 x 2-1/8 inch deep junction box is
recommended.The junction box must not interfere with fixture
focusing.
The fixture is factory pre-wired. Opening the housing is not
required.
The fixture must be connected to a non-dimmable power
source. Dimming the unit will damage the fixture and void the
factory warranty.
Power Connections
Mains Europe North America
Line Brown Black
Neutral Blue White
Ground Green/Yellow Green