Installation, Termination – ETC Desire D22 User Manual
Page 4
Advertising
4
Desire Series D22
Installation
Termination
The D22 Desire Series requires termination at the last fixture on a DMX/RDM line
with a 120 ohm resistor.
• The Portable fixture is self terminated.
• The Track fixture is terminated with a DataTrack DMX Term Block, ETC Part
# 7066A1030.
• The Canopy fixture is terminated on the Termination board inside the
canopy.
Canopy Fixture Mounting Plate and Termination Board
Termination
The Canopy fixture is terminated with the S1 switch on the Termination board. Set
the switch to the ON position to terminate the last fixture. All others on the
DMX/RDM line must be set to OFF.
Termination
board
Power block
Mounting plate
Termination switch
D22 Data connector
Advertising