Wlan adsl2+ router, 0 hardware requirements, 1 setting up the hardware environment – HiRO H50188 User Manual
Page 8: 2 powering on wlan adsl2+ router
6
WLAN ADSL2+ Router
3.0 Hardware Requirements
To use WLAN ADSL2+ Router, please have following hardware / accessories ready.
A PC with Pre-installed Ethernet Adapter (Required)
12Vac power adaptor (Included in the package)
RJ-45 Ethernet cable (Included in the package)
RJ-11cable (Included in the package)
3.1 Setting up the Hardware Environment
Please kindly refer to chapter 4.2 “Installation & Setup”
3.2 Powering on WLAN ADSL2+ Router
1. Connect the power to the WLAN ADSL2+ Router by plugging the power supply into
an appropriate electrical outlet.
2. If the Power LED is off, refer to “Troubleshooting” for information.
Please kindly refer to chapter 4.2 “Installation & Setup”
Note!
Be sure that you are well insulated from any power source to avoid
electricity shock.
Note!
Use only the manufacturer-approved power supply that shipped with the
WLAN ADSL2+ Router.