Baracoda 2 - Manual (Page 12)

BaracodaPencil 2 – Communication Protocol v1.3 - 12 -
Data Capture
for Workforce
in Motion
For each step:
{(Bit 6: Blue LED 1) (Bit 5: Red LED 1) (Bit 4: Green LED 1) (Bit 2: Blue LED 0) (Bit 1: Red
LED 0) (Bit 0: Green LED 0)}
{Buzzer frequency, 0 – 0xFF * 50Hz = 0 – 12750Hz}
{Delay until next step, in tenth of seconds}
Response 1 byte: {(Bit 0: Success)}
Code ID 0x8A-0x8B
Description Play Signal
Payload 2 bytes:
{Signal number, 0 - 3}
{Number of loops, 0 – 0xFE, 0xFF = infinity}
Response 1 byte: {(Bit 0: Success)}
Code ID 0x8C-0x8D
Description Stop Signal
Payload 1 byte:
{Signal number, 0 – 3}
Response 1 byte:
{(Bit 0: Success)}
The list of MMI signals is:
IHM_SIGNAL_CAPTURE_READ : 0
IHM_SIGNAL_CAPTURE_ACK : 1
IHM_SIGNAL_CAPTURE_NAK : 2
IHM_SIGNAL_CAPTURE_LOST : 3
Code ID 0x92-0x93
Description Get Beeps mode
Payload
Response 1 byte:
{(Bit 0: Beep level 0=low, 1=high)
(Bit 1: Read beep)
(Bit 2: ACK beep)}
Code ID 0x94-0x95
Description Set Beeps mode
Payload 1 byte:
{(Bit 0: Beep level; 0=low, 1=high)
(Bit 1: Read beep)
(Bit 2: ACK beep)
(Bit 7 = 0: ACK beep config select, =1: ACK beep config deselect)
(Bit 6 = 0: Read beep config select, =1: Read beep config deselect)
(Bit 5 = 0: Beep level config select, =1: Beep level config deselect)}}