Baracoda 2 - Manual (Page 15)

BaracodaPencil 2 – Communication Protocol v1.3 - 15 -
Data Capture
for Workforce
in Motion
Code ID 0xC8-0xC9
Description Get / Set Barcode length
Payload Get : None
Set : 2 bytes
{authorized barcode length. 0 = disabled}
Response Get : 2 bytes
{authorized barcode length. 0 = disabled}
Set : 1 byte
{(Bit 0:Success)}
Code ID 0xCA-0xCB
Description Get and erase stored barcodes with no data loss mode
Payload None
Response 1 byte
{(Bit 0:Success)}
Code ID 0xCC-0xCD
Description Reset modes
Payload None = restore defaults, keep link keys, reboot scanner
1byte :
0 = restore defaults, keep link keys, reboot scanner
1 = switch off scanner (no restoring defaults)
2 = reboot scanner (no restoring defaults)
Response 1 byte
{(Bit 0:Success)}
Code ID 0xCE-0xCF
Description Batch upload commands
Payload {Code ID} “Parameters” (cf. below)
Response {Code ID} “Response”
The UPLOAD Code IDs are:
Code ID 0
Description Launch upload process (typically used only for the upload barcode)
Payload 1 byte:
{0 mandatory}
Response 1 byte:
{Bit 0: Success}
Code ID 1
Description Ready to start upload (Scanner to host message)
Payload 3 bytes :
{0 mandatory}