Baracoda 2 - Manual (Page 9)

BaracodaPencil 2 – Communication Protocol v1.3 - 9 -
Data Capture
for Workforce
in Motion
2.3.2. 2.3.2. 2.3.2. 2.3.2. Scanner messages Scanner messages Scanner messages Scanner messages
Code ID 0x60-0x61
Description Get Scanner Status
Payload None
Response 2 bytes:
{(Bit 7: Upgrading) (Bit 1: Docked) (Bit 0: Charging)}
{Battery level, 0 to 100}
Code ID 0x62-0x63
Description Get Operating Mode
Payload None
Response 1 byte:
{Bit 0 = 0:real time, Bit 0 = 1: batch}
{(Bit 7: limited)}
Remarks “limited” means barcode buffer = 0 when in real time, no data loss mode and
disconnected
Code ID 0x64-0x65
Description Set Operating Mode
Payload 1 byte:
{Bit 0 = 0: real time, Bit 0 = 1: batch}
If real time mode is set :
{(Bit 7: limited)(Bit 6: ACK beep) (Bit 5: no ACK beep)}
NOTE : the ACK beep enable / disable is only effective when Capture Frame Format is
“Baracoda + ACK”
Response 1 byte:
{Bit 0: Success}
Remarks Batch mode is not available for D-Fly scanner
Code ID 0x66-0x67
Description Get Shutdown Timers
Payload None
Response 2 bytes:
{Number of minutes before shutdown when connected, 1 to 0xFE,
0xFF = infinity}
{Number of minutes before shutdown when disconnected, 1 to 0xFE,
0xFF = infinity}
Code ID 0x68-0x69
Description Set Shutdown Timers
Payload 2 bytes:
{Number of minutes before shutdown when connected, 1 to 0xFE,
0xFF = infinity}